Mr. Kouichi Fujii Profile

Kouichi Fujii

at Gigaphoton Inc.

SPIE Involvement:

Author

Publications (2)

Proceedings Article | 10 April 2024 Poster

Analyzing line width roughness (LWR) sensitivity to resist and laser-induced speckle for enhanced PSD-based quantification

Takamitsu Komaki, Tomohiro Iwaki, Yuichi Mukai, Kouichi Fujii, Toshihiro Kobayashi, Toshihiro Ohga, Kouji Kakizaki, Takashi Saito, Risa Yasue, Natsuki Okada, Katsunori Otsuki, Tomonori Okada, Kanji Sugino, Takahito Kumazaki

Proceedings Volume PC12953, PC129530S (2024) https://doi.org/10.1117/12.3008944

KEYWORDS: Speckle, Line width roughness, Semiconductors, Scanners, Lithography, Light sources, Chromatic aberrations

Read Abstract +

Proceedings Article | 26 May 2022 Presentation + Paper

Spectrum optimization during SMO: simultaneous source-mask-laser spectrum optimization

Evgeny Malankin, Neal Lafferty, Mikhail Silakov, Ekaterina Semenova, Takamitsu Komaki, Kouichi Fujii, Taisuke Miura, Gouta Niimi, Taku Yamazaki

Proceedings Volume 12052, 1205205 (2022) https://doi.org/10.1117/12.2614055

KEYWORDS: Source mask optimization, Electroluminescence, Metals, Photomasks, Light sources, Logic, SRAF, Lithography, Chromatic aberrations, Excimer lasers

Read Abstract +

Tuning the spectrum of a scanner’s excimer laser light source is a well-known technique to achieve improved depth of focus (DOF) for an exposure. Previous studies have focused on the imaging improvement capabilities of readily available spectral shapes such as Gaussian E95 single peak width, as well as dual-peak spectral shapes where the spacing of the peaks can be varied. It is commonly known that adjustments in the laser spectrum must be carefully considered since exposure latitude (EL) can also be reduced as DOF is increased. By carefully engineering the laser’s spectrum, DOF can be maximized with very little impact to exposure latitude. Undesirable speckle contrast can also be reduced as laser bandwidth is increased. Traditionally, these approaches have been used to improve DOF of thick resist applications such as CMOS image sensors. Other areas such as NAND Flash have introduced laser spectrum engineering (SE) to compensate for topography effects between periphery and array regions. Recently, advances in laser hardware have enabled new and unique spectral shapes to be used for imaging. In this paper, we explore the various spectral profiles possible on the latest Gigaphoton GT66A ArFi light sources. New applications of these spectrum shapes are considered for foundry logic-type levels. First, a representative 14nm-node logic layer is considered. Source Mask Optimization (SMO) is performed while various widths of spectral profiles are used as input, such as traditional E95 Gaussian profiles, dual-peak, and flat top. By accounting for the laser spectrum during SMO, common DOF can be improved by ≥ 20% without a noticeable decrease in exposure latitude. The SMO sources and optimized masks are also different from each other and the nominal cases, depending on the spectral distribution used. Next, we explore simultaneously optimizing the laser spectrum, source, and mask in an experimental SMO+SE. Spectra can be constrained to keep symmetric profiles about the 193nm center point. Improved lithographic performance can result from the application of programmable laser spectra combined with pixelated sources and inverse lithography (ILT).

View contact details

UPDATE YOUR PROFILE

Is this your profile? Update it now.

Sign into your SPIE.org account

Don’t have a profile and want one?

Create an account on SPIE.org

Keywords/Phrases

Search In:

Publication Years