Paper
3 May 2004 Comparison of CMOS and CCD cameras for laser profiling
Author Affiliations +
Proceedings Volume 5303, Machine Vision Applications in Industrial Inspection XII; (2004) https://doi.org/10.1117/12.529868
Event: Electronic Imaging 2004, 2004, San Jose, California, United States
Abstract
The recent introduction of high dynamic range CMOS-cameras with logarithmic response to light intensity, justify a serious evaluation of the technology as an alternative technology for laser profiling. This paper presents a series of comparative tests of a high quality CCD-camera and a high-dynamic range CMOS-camera. Standard gray scale charts are used to verify the intensity response and the signal to noise ratio at different f-stops. It is shown that the high dynamic range of the CMOS-sensor makes the camera suitable for differential image laser profiling. Furthermore, the cross-section of steel rods and wires are observed to verify the industrial applicability of the different standards. Both, material at room temperature and red-hot glowing steel bars were measured. The advantages and disadvantages for each technology are shown on the basis of these tests. Finally, a laser profiler was manufactured with the CMOS-camera and successfully implemented in a steel-mill.
© (2004) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Norbert Koller D.D.S., Paul O'Leary, and Peter Lee "Comparison of CMOS and CCD cameras for laser profiling", Proc. SPIE 5303, Machine Vision Applications in Industrial Inspection XII, (3 May 2004); https://doi.org/10.1117/12.529868
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
CCD cameras

Cameras

Profiling

High dynamic range imaging

Laser applications

Interference filters

Light sources

RELATED CONTENT

Low-cost laser-beam analyzer
Proceedings of SPIE (June 06 2002)
Using the EMVA1288 standard to select an image sensor or...
Proceedings of SPIE (January 25 2010)
A new device for dynamic luminance mapping and glare risk...
Proceedings of SPIE (October 11 2012)
Beam profiling monitors beam shaping
Proceedings of SPIE (August 29 2005)

Back to Top