Recent CD AFM probe developments for sub-45 nm technology nodes

Hao-Chih Liu; Jason R. Osborne; Gregory A. Dahlen; Johann Greschner; Thomas Bayer; Samuel Kalt; Georg Fritz

doi:10.1117/12.773057

9 April 2008 Recent CD AFM probe developments for sub-45 nm technology nodes

Hao-Chih Liu, Jason R. Osborne, Gregory A. Dahlen, Johann Greschner, Thomas Bayer, Samuel Kalt, Georg Fritz

Proceedings Volume 6922, Metrology, Inspection, and Process Control for Microlithography XXII; 69222J (2008) https://doi.org/10.1117/12.773057
Event: SPIE Advanced Lithography, 2008, San Jose, California, United States

Abstract

This paper reports on new developments of advanced CD AFM probes after the prior introduction of "trident probes" in SPIE Advanced Lithography 2007 [1]. Trident probes, having sharpened extensions in the tip apex region, make possible bottom CD measurements within a few nanometers of the feature bottom corner; an area where other CD probes have difficulties due to tip shape limitations. Moreover, new metrology applications of trident probes have been developed for novel devices such as FinFET and vertical read/write hard disk heads. For ever smaller technology nodes, new probes evolved from the design of the trident probe. For example, the number of sharpened tip flares was reduced from three (trident) to two (bi-pod) to prevent possible interference of the third leg in the slow scan direction, as shown in Figure 3. Maintaining tip lateral stiffness as the tip size shrinks to less than 30 nm is vital for successful scanning. Consequently, a significant recent improvement is the change of probe shank cross-sectional geometry in order to maintain tip vertical aspect ratio of 1:5 (and lateral stiffness > 1 N/m). Finally, modifications of probe substrate are proposed and evaluated for current and new CD AFM systems. Hydrophobic, self-assembled monolayer (SAM) coatings were applied on CD probes to reduced tip "pull-away" distance1 during CD AFM scanning. Test results show that the pull away distance can be reduced more than 5 times on average (in some cases, by a factor of 15). Consequently, use of hydrophobic SAM coatings on CD probes mitigates pull-away distance thus allowing narrow trench CD measurements. We discuss limitations of prior CD AFM probes and design considerations of new CD probes. The characterization of first prototypes and evaluation of scan performance are presented in this work.

Citation Download Citation

Hao-Chih Liu, Jason R. Osborne, Gregory A. Dahlen, Johann Greschner, Thomas Bayer, Samuel Kalt, and Georg Fritz "Recent CD AFM probe developments for sub-45 nm technology nodes", Proc. SPIE 6922, Metrology, Inspection, and Process Control for Microlithography XXII, 69222J (9 April 2008); https://doi.org/10.1117/12.773057

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available